LUBRIPLATE PGO 320, 1 gal., (1 JUG/EA)

The LUBRIPLATE PGO Series is comprised of 100% polyalkylene glycol (PAG) products which are designed to handle the most demanding operating conditions. The LUBRIPLATE PGO Gear Oils may be recommended for helical, bevel helical, planetary and worm gear reducers. These fluids deliver outstanding protection against micropitting, abrasion and wear. They deliver unsurpassed extreme pressure and anti-wear performance and provide outstanding thermal stability. Materials compatibility with PAG synthetic fluids is an important consideration. Polyurethane based elastomers, leather, cork, paper and board should be avoided. Common seal and gasket materials are unaffected by the LUBRIPLATE PGO fluids. Nitrile Rubber (NBR), fluoroSilicone or vinyl-methyl polysiloxane (Q) are recommended especially where high temperatures are involved. Ordinary industrial paints will soften in the presence of the LUBRIPLATE PGO Gear Oils. Internal gearbox surfaces should ideally be unpainted or coated with resistant materials, for example a resistant two-pack epoxy formulation. The LUBRIPLATE PGO Gear Oils are not compatible, nor should they be mixed, with mineral oil-based lubricants or polyalphaolefin (PAO) based fluids. When changing from a mineral oil or a PAO to one of the LUBRIPLATE PGO fluids, the following flushing procedure should be followed: The system should be run until the old oil is warm, then drain as fully as possible, particular attention being paid to reservoirs, lines etc., where oil may be trapped. The system should be cleaned of residual sludge. Flush the system with the minimum quantity of LUBRIPLATE PGO Fluid by operating under no load then drain the system while the fluid is warm. Repeat if necessary. Seals, etc., should be inspected and if deteriorated, then replaced. Seals previously exposed to other oils may shrink when exposed to LUBRIPLATE PGO Gear fluids, therefore, it may be advantageous to replace them, however, this is not mandatory. Careful inspection of the system for leaks will often suffice. It is useful to inspect the lubricant after one or two days in use to make sure that it is free of extraneous materials. Contamination with significant quantities of other lubricants can, in some cases, lead to sludging, foaming and other problems.